A Study on ARL Performance of Ewma Control Chart

Cite this:
Goswami, A., & Dutta, H. (2014). A Study on ARL Performance of Ewma Control Chart. Asian Journal of Current Engineering and Maths, 3(4), 39–41. https://doi.org/10.15520/ajcem.2014.vol3.iss4.1.pp39-41.
© 2022 Interactive Protocols
RIGHTS & PERMISSIONS
Article Views
157
Altmetric
1
Citations
-
LEARN ABOUT THESE METRICS
   PDF  

Abstract

Shewhart chart has been widely used in determining shift in a process, however the main disadvantage of any Shewhart charts is that they use only the last information of the combined process and ignore any other process given by the sequence of all points. This characteristics makes Shewhart control charts relatively insensitive to a small changes in a process, because the cumulative or weight of the previous observation are disregarded. Small changes could be detected through Cumulative Sum (CUSUM) and Exponentially Weighted Moving Average (EWMA) control charts. Crowder (1987, 1989) and Lucas & Saccucci (1990) presented the exponentially weighted moving average control chart, as good choice to detect small change in process average. A number of authors have studied the design of EWMA control scheme based on Average Run length (ARL) computation. Ideally, the ARL should be short when a shift occurs and should be long when there is no shift. In this paper, an attempt has been made to evaluate the run-length properties of EWMA control chart by using the Markov Chain approach. This study provides ARL tables for a range of values of λ and L.

KEYWORDS:

 Special Issue

Article Metrics Graph

Chart Graph | Range Graph

Content

Section

Source

License

COPYRIGHT AGREEMENT AND AUTHORSHIP RESPONSIBILITY

 

All paper submissions must carry the following duly signed by all the authors:

“I certify that I have participated sufficiently in the conception and design of this work and the analysis of the data (wherever applicable), as well as the writing of the manuscript, to take public responsibility for it. I believe the manuscript represents valid work. I have reviewed the final version of the manuscript and approve it for publication. Neither has the manuscript nor one with substantially similar content under my authorship been published nor is being considered for publication elsewhere, except as described in an attachment. Furthermore I attest that I shall produce the data upon which the manuscript is based for examination by the editors or their assignees, if requested.”