Mathematical Modeling Of Sepic Converter With Continuous Conduction Mode (CCM) For Solar Maximum Power Tracking Application

Cite this:
SAVIO, M. (2015). Mathematical Modeling Of Sepic Converter With Continuous Conduction Mode (CCM) For Solar Maximum Power Tracking Application. Asian Journal of Current Engineering and Maths, 4(6), 78–82. https://doi.org/10.15520/ajcem.2015.vol4.iss6.36.pp78-82.
© 2022 Interactive Protocols
RIGHTS & PERMISSIONS
Article Views
138
Altmetric
1
Citations
-
LEARN ABOUT THESE METRICS
   PDF  

Abstract

In this paper, a single ended primary-inductor converter (SEPIC) is applied for the solar power application. The solar power is tracked electrically using DC-DC converter such that the maximum power is extracted from the solar panel throughout its operation. The proposed converter uses a single inductor to allow a continuous-conduction mode by making the current never fall to zero. The proposed converter is controlled using the fuzzy logic controller that operates both in buck and the boost operation; unlike the conventional methods the output is non-inverted. The SEPI Converter used is more applicable for the maximum power tracking method because the output of the SEPIC is independent of the input voltage as the average current through the inductor is same as the load current. The proposed method is simulated using the MATLAB program. An experimental verification is done for a DC motor operated by Fuzzy controlled SEPIC and the results are shown

KEYWORDS:

 Special Issue

Article Metrics Graph

Chart Graph | Range Graph

Content

Section

Source

License

COPYRIGHT AGREEMENT AND AUTHORSHIP RESPONSIBILITY

 

All paper submissions must carry the following duly signed by all the authors:

“I certify that I have participated sufficiently in the conception and design of this work and the analysis of the data (wherever applicable), as well as the writing of the manuscript, to take public responsibility for it. I believe the manuscript represents valid work. I have reviewed the final version of the manuscript and approve it for publication. Neither has the manuscript nor one with substantially similar content under my authorship been published nor is being considered for publication elsewhere, except as described in an attachment. Furthermore I attest that I shall produce the data upon which the manuscript is based for examination by the editors or their assignees, if requested.”